Digital Food Smoker

How do I safely operate the Bradley Smart Smoker?

• Do not leave the smoker unattended.
• Do not touch hot surfaces.
• Do not immerse cords or plugs in water or any liquids.
• Close supervision is necessary when any appliance is used by or near children.
• Always unplug smoker when not in use.
• Do not operate with damaged cords.
• Do not modify your smoker from its original state.
• Do not place on or near a hot gas or electric burner, or in a heated oven.
• Clean up grease and cool down your smoker before moving it around.
• Always attach plug to appliance first, then plug into the outlet.
• Do not use the appliance for other than its intended use.
• Do not use any other type of wood other than Bradley Flavor Bisquettes®.
• Lift and move smoker with care to prevent strains and back injuries.
• Use caution when reaching into or around the smoker – surfaces are hot.
• It is recommended to have a fire extinguisher near the smoker.

What do I need to know before starting up the smoker?

• Use the smoker outdoors only.
• Do not expose the smoker to rain, keep it sheltered and protect it from water.
• Do not plug in the smoker before it is fully assembled.
• Do not cover or seal the racks with any foil.
• Fill up the drip bowl inside of the smoker with water before use.
• Empty and refill the drip bowl of water and burnt bisquettes every 2 to 3 hours.

What do I need to do after the smoking cycle has been completed?

• Cool the smoker down.
• Unplug all the electrical cords.
• Clean the drip bowl and dispose of all burnt bisquettes carefully as they may still be hot.
• Wash the drip tray, racks, bottom rectangular tray and drip bowl to remove grease.
• Wipe inside with damp cloth to remove food and grease residue.
• Clean the bisquette burner slightly by using brush or scraper.
• Do not use any kind of appliance cleaners for inside cleaning purposes.
• Store the smoker in a dry place.

What should I do if the smoker is not powering up?

• Check that all plugs are correctly and firmly inserted into sockets.
• Check the fuse on the smoker.
• Check the fuse to make sure the outlet, Ground Fault Circuit Interrupter (GFCI), has not been tripped.

What do I need to do if bisquettes will not advance and I see the “E” error?

• Check the drive guide and clear all loose wood chips.
• Open the generator and see if the bisquette pusher is reaching the end sensor.
• Make sure that the bisquette pusher motor is rotating.
• If you still cannot get the pusher working, please call customer service at +4 0234 555 959.

What do I need to do if I see the “E1” error?

• This error indicates that the generator is not receiving the sensor signal from the smoker.
• Check that the sensor cable is properly connected at the back side of the generator and between the smoker.
• If you still see the error, please call customer service at +4 0234 555 959.

What should I do I if my smoker is not heating up at all?

• Check that the long power cord is properly connected at the back side of the generator and in the wall plug.
• Check that the short power cord is properly connected at the back side of the generator and between the smoker.
• Make sure that your oven is turned on.
• If your oven is still not heating up, please call customer service at +4 0234 555 959.

What is it that you need to know?